U-Line 2000 Series Guide de dépannage télécharger pdf (Page 12)

u-line.com 9

Removing and Installing Grille

WARNING

Disconnect electric power to the unit before removing

the grille.

WARNING

DO NOT touch the condenser fins (4). The condenser

fins are SHARP and can be easily damaged.

Removing the grille.

1. Disconnect power to the unit.

2. Loosen the two screws (1).

3. Remove grille (2) from unit.

Installing the grille:

1. Place the hook-hinge located on the rear bottom side of the

grille (2) onto the front lip of the unit base. Swing the grille up

into position.

2. Align cabinet and grill holes and secure, but do not overtighten

grille screws (1).

3. Reconnect power to the unit.

Typical Model Shown

Removing and Installing Door Shelves

For models equipped with door shelves:

To r e m o v e t h e d o o r s h e l f :

1. Grasp shelf in center, and lift until the shelf notches (1) clear

the pins (2).

2. Carefully pull the shelf away from the door.

To install the door shelf:

1. Holding the shelf in the center, center the shelf in the door at

the desired location, slightly above the pins (2).

2. Lower the shelf onto the pins (2).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

Pas de commentaire

U-Line 2000 Series Guide de dépannage Page 12