U-Line CLR60 Manuel d'utilisateur

RR RCP.O. Box 245040Milwaukee, WI 53224-9540Phone 414.354.0300FAX 414.354.7905CLR60CLEAR ICE MACHINEPrinted in U.S.A.P/N 41952User’User’s Manuals Manu

• Overall maximum outside dimensions of 8-3/4" wide x 5-3/4" deepx 7-3/4" high.• Minimum flow rate of 15 gallons per hour at 10 feet

6. Install a 1/4 inch copper water line (not supplied with unit) fromthe nearest COLD water pipe. When connecting the water supply,follow these guid

• Install a shut-off valve in the 1/4 inch supply line.• Connect sufficient tubing tothe unit to allow the unit to bemoved for cleaning and ser-vicing

4. Locate the compression fit-ting and ferrule packed in theunit. Slide the compressionfitting and ferrule over the1/4 inch water supply line.Do not

NOTE After completing the installation, turn on the water andrecheck water and drain connection for leaks. Apply addi-tional tightening if needed. D

3. Check the levelness after each adjustment and repeat the previoussteps until the unit is level.GRILLE INSTALLATION1. With a standard blade screwd

3. Place the twohook-hinges (locat-ed on the rearbottom side of thegrille) on the frontlip of the unitbase. Swing thegrille up into posi-tion, align

5. Install hinge on oppositeside, bottom of cabinet (seeFigure 18). Replace nut onback side where installed.Align hinge outer edge withcabinet befor

8. Remove pivot screw fromtop hinge, invert screw andreinstall pivot screw in tophinge (see Figure 20).9. Remove three plastic plugsin hinge holes,

13. Replace three plastic plugs removed in step 8 into holes on top ofunit. Replace screws in holes in bottom of unit, opposite side.14. Reinspect do

U-LINE CORPORATION LIMITED WARRANTYU-Line Corporation warrants each U-Line product to be free from defects in materials andworkmanship for a period of

Figure 23UL131 Custom Door Panel DimensionsModel A BCLR 60 28-5/32" 13-15/16"CLR 60SS 29-13/32" 13-15/16"SS - Stainless steel u

7. Holding door gasket out of theway, replace handle on doormaking sure it is seated prop-erly on insert and that screwholes line up.8. Install two

INITIAL START-UPOnce installation and leveling is complete, the unit is ready for initialstart-up and operation.1. Plug the appliance cord into a 115

21UL227CLNOFFICEFigure 27NORMAL OPERATIONThe ice maker is designed to make clear ice from most water sourceson a consistent basis. Water is constantl

ADJUSTING ICE THICKNESSThe ice thickness control is set toautomatically maintain an icebridge of 0.16-0.32 cm (1/16-1/8 inch) thick. A dimple in each

NOTEIce thickness adjustment dial should be turned only oneincrement at a time. Allow unit to stabilize for 24 hoursbefore making further adjustments

24User’s ManualUL005AFigure 30UL204C Figure 31INLET SCREEN CLEANINGThe solenoid valve inlet screenmust be cleaned at least once eachyear as follows:1.

Use only U-Line Ice Machine Cleaner (part number 41978).It is a violation of Federal law to use this solution in a man-ner inconsistent with its label

7. When water begins to flowover the evaporator (approxi-mately 3 minutes), add onepackage of U-Line IceMachine cleaner to thewater reservoir.8. Reins

STORAGE, VACATION AND MOVINGIf the unit is to be stored, moved or not used for extended periods, itwill be necessary to drain the system of water.Elec

INTRODUCTIONCongratulations on your purchase of a U-Line CLR 60 Ice Maker. A pio-neer in the field for more than 35 years, U-Line is the world’s numb

TROUBLESHOOTINGBEFORE CALLING FOR SERVICEIf the unit appears to be malfunctioning, read through NORMAL OPER-ATION first. If the problem persists, chec

Problem Possible Cause RemedyUnit runs but Inadequate airflow at Remove items blocking produces very the front of the unit airflowlittle iceIce thi

Problem Possible Cause RemedyWater leaking Supply line leaking Check to see that water from under the inlet line is attached to unit inlet valve pro

31Notes_______________________________________________________________________________________________________________________________________________

Notes_________________________________________________________________________________________________________________________________________________

RR RCP.O. Box 245040Milwaukee, WI 53224-9540Phone 414.354.0300FAX 414.354.7905CLR60CLEAR ICE MACHINEPrinted in U.S.A.P/N 41952User’User’s Manuals Manu

If you do not return your Warranty Registration Card, U-Line will usethe date of sale to the U-Line distributor as the first date of warrantyfor your

SAFETY PRECAUTIONSDo not attempt to install or operate your unit until you have read thesafety precautions in this section. Safety items throughout t

4User’s Manual• Never install the unit behind closed doors. Be sure frontgrille is free of obstruction. Obstructing free air flow cancause the unit

5DRAIN INSTALLATIONPLEASE READ all instructions completely before attemptingto install or operate the unit. All Ice Makers require a con-nection to th

To prevent accidental electrocution, make certain that thefloor surfaces surrounding the unit are dry whenever poweris removed from, or applied to th

5. Place a suitable container beneath the pump’s discharge tube.(The bucket must be able to hold a minimum of one gallon.)Back panel serves as a guard