U-line 2075 Manuel d'utilisateur télécharger pdf (Page 15)

5. On a clean surface, place the wood panel face down and tape the

existing drawer panel (removed in step 3) on the back of the wood

panel (Figure 10) and drill the five (5) holes (5/32" drill 3/8" deep)

through the coated steel panel and 3/8" into the wood panel

according to the diagram (Figure 11). Remove tape from the draw-

er panel, and enlarge the five holes in the front panel using a .0201"

drill (#7) drill.

Figure 10

Figure 11

COATED STEEL

DRAWER PANEL

BOTTOM OF

WOOD PANEL

BACK OF

WOOD PANEL

NOTE:

For 1/2" gap between

top and bottom panels,

this dimension must be

11/32". For 1/4" gap, this

dimension must be 19/32"

for TOP PANEL ONLY.

TAPE

3/8" BOTH SIDES

DWR_OL_003

SIDE OF

WOOD PANEL

2-15/16"

TOP OF WOOD PANEL

5/32" X 3/8" DEEP

5 PLACES

COATED STEEL

DRAWER PANEL

23-3/4"

11-7/8"

DWR_OL_004

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 30 31

Pas de commentaire

U-line 2075 Manuel d'utilisateur Page 15