U-Line 1115R Guide de dépannage télécharger pdf (Page 16)

u-line.com 13

Wire Shelf Removal/Installation

For ADA models equipped with wire racks, reposition the shelves

as follows:

Figure 1

1. Remove shelf retention clip.

2. Pull shelf out about 6"

(1)

, until back of shelf clears the “hump”

on the right-hand side.

3. Tilt up right-hand edge of shelf

(2)

4. Remove shelf from unit by pulling out

(3)

Insert the shelves as follows:

1. To move to a different position in the unit, insert shelf at an

angle, approximately 15-20°, over the rib in the side of the unit

where you want to place the shelf. The shelf must be started

into the unit at an angle to clear the door.

2. Continue to slide the shelf into the unit at an angle until it clears

the door.

3. Lower the shelf and push it in completely.

Install shelf retention clip.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

U-Line 1115R Guide de dépannage Page 16